Delete a UM IP gateway in Exchange Server
Applies to: Exchange Server 2013, Exchange Server 2016
When you delete a Unified Messaging (UM) IP gateway, Exchange servers can no longer accept incoming calls from the Voice over IP (VoIP) gateway, Session Initiation Protocol (SIP)-enabled Private Branch eXchange (PBX), IP PBX, or session border controller (SBC) associated with the UM IP gateway.
Important
You should delete a UM IP gateway only when you fully understand the implications of disabling communication with a VoIP gateway, IP PBX, or SBC.
For additional tasks related to UM IP gateways, see UM IP gateway procedures.
What do you need to know before you begin?
Estimated time to complete: Less than 1 minute.
You need to be assigned permissions before you can perform this procedure or procedures. To see what permissions you need, see the "UM IP gateways" entry in the Unified Messaging permissions topic.
Before you perform these procedures, confirm that a UM dial plan has been created. For detailed steps, see Create a UM dial plan.
Before you perform these procedures, confirm that a UM IP gateway has been created. For detailed steps, see Create a UM IP gateway.
For information about keyboard shortcuts that may apply to the procedures in this topic, see Keyboard shortcuts for the Exchange admin center in Exchange 2013.
Tip
Having problems? Ask for help in the Exchange forums. Visit the forums at Exchange Server.
Use the EAC to delete a UM IP gateway
In the EAC, navigate to Unified Messaging > UM IP Gateways, select the UM IP gateway you want to delete, and then click Delete
.On the Warning page, click Yes.
Use the Shell to delete a UM IP gateway
This example deletes the UM IP gateway named MyUMIPGateway.
Remove-UMIPGateway -Identity MyUMIPGateway