Debugger2.StepOver Method
Steps over the next function call.
Namespace: EnvDTE80
Assembly: EnvDTE80 (in EnvDTE80.dll)
Syntax
'Declaration
Sub StepOver ( _
WaitForBreakOrEnd As Boolean _
)
void StepOver(
bool WaitForBreakOrEnd
)
void StepOver(
[InAttribute] bool WaitForBreakOrEnd
)
abstract StepOver :
WaitForBreakOrEnd:bool -> unit
function StepOver(
WaitForBreakOrEnd : boolean
)
Parameters
WaitForBreakOrEnd
Type: BooleanSet to true if this function call should wait until either Break mode or Design mode is entered before returning. Set to false if you want this call to return immediately after causing the debugger to begin execution. Upon return the debugger could be in Design, Break, or Run modes.
Remarks
See Code Stepping Overview for more information.
Examples
The following example demonstrates how to use the StepOver method.
To test this method:
Set a breakpoint on the function call in the target application.
Run the target application in the debug mode.
When the application stops at the breakpoint, run the add-in.
public static void StepOver(EnvDTE80.DTE2 dte)
{
EnvDTE80.Debugger2 debugger = (EnvDTE80.Debugger2)dte.Debugger;
debugger.StepOver(true);
}
Sub StepOverAndNotify
DTE2.Debugger.StepOver(True)
MsgBox("The debugger stepped over the call.")
End Sub
.NET Framework Security
- Full trust for the immediate caller. This member cannot be used by partially trusted code. For more information, see Using Libraries from Partially Trusted Code.