Share via

Configuring the Gateway Registry (Windows Embedded CE 6.0)

  • Article

1/5/2010

In the following procedure, modifying the project registry file makes a persistent change to your Gateway run-time image.

To configure the registry for your gateway

  1. In the Solution Explorer window, expand the ParameterFiles node.

  2. Expand the <BSP name> node and navigate to the project.reg file.

  3. Double-click project.reg to open the file.

  4. In the Source tab, add the following registry key and values to the bottom of the file:

    [HKEY_LOCAL_MACHINE\Comm\ConnectionSharing]
"EnableAddressTranslation"=dword:1
"EnableDhcpAllocator"=dword:1
"EnableDnsProxy"=dword:1
"PublicInterface"="VMINI1"
"PrivateInterface"="PCI\\<private network interface>"
[HKEY_LOCAL_MACHINE\Comm\PCI\<private network interface>\Parms\Tcpip]
"IPAddress"="192.168.0.1"
"SubnetMask"="255.255.255.0"
"EnableDHCP"=dword:0
"DhcpMaxRetry"=dword:ffffffff

    In this example, you are using the VMINI adapter for the public interface and PCI\NE20001 for the private interface. You are also assigning a static IP address of 192.168.0.1 to the private interface.

    Note

    If you use a different adapter for your public interface, you must replace the VMINI1 value for the PublicInterface key with the appropriate adapter name.

    Note

    The static IP address of 192.168.0.1 is also used in the Firewall rules as the default for the SourcePrivate registry value. If you want to use a different static address for the private interface, you must change the SourcePrivate registry value to match this address. For more information, see Default IP Firewall Rules.

    The <Private Interface Name> and <Public Interface Name> interface names depend on the network adapters the gateway uses. For example, if it uses an NE2000-compatible network adapter for the private interface, you would type:

    "PrivateInterface"="PCI\\NE20001"

    When configuring the registry settings for TCP/IP, you must also insert the name of the private interface, as shown in the following example:

    [HKEY_LOCAL_MACHINE\Comm\PCI\NE20001\Parms\Tcpip]

    For information about the supported network cards and interface names, see the Driver Support section under Gateway Hardware Requirements.

    Note

    Interface or adapter names are a common source of errors when creating an OS design. To verify the interface or adapter names and the IP addresses for these adapters on your target device after downloading the image, type s ipconfig /d /all in the Target Control window of Platform Builder. The Debug output window displays the IP address of the target device and shows the interface or adapter names.

  5. Save and close the file.

See Also

Concepts

Gateway Registry Settings

Other Resources

Customizing a Gateway