FMD_GetBlockStatus (Windows Embedded CE 6.0)
1/6/2010
This function returns the status of a block.
Syntax
DWORD FMD_GetBlockStatus(
BLOCK_ID blockID
);
Parameters
- blockID
[in] The block number used to check status.
Return Value
The following table shows the flags that can be returned to describe the status of the block.
| Flag | Description |
|---|---|
BLOCK_STATUS_UNKNOWN |
The status could not be determined as a result of a read error. |
BLOCK_STATUS_BAD |
The block is bad. |
BLOCK_STATUS_READONLY |
The block is read-only. |
BLOCK_STATUS_RESERVED |
The block is reserved. |
BLOCK_STATUS_XIP |
The block is an execute-in-place (XIP) block. This flag is returned by a flash media driver (FMD) if the driver is in update mode and the block identifier that is being queried is an XIP block. The BLOCK_STATUS_XIP flag is only returned if the run-time image is an update loader image. If the run-time image is not an update loader image, this function returns BLOCK_STATUS_READONLY for an XIP block as data cannot be written to the block. |
Remarks
It is the responsibility of the caller of the FMD to check and interpret the block status. If the FMD is used with the FAL, then a read-only block will be mapped to a logical sector but will not allow write access. A reserved block will not be mapped to a logical sector and therefore will not be used by the FAL. A bad block will be ignored.
Requirements
| Header | fmd.h |
| Library | Developer Implemented |
| Windows Embedded CE | Windows CE .NET 4.2 and later |