Share via

DOT11_EXTSTA_SEND_CONTEXT (Compact 7)

  • Article

3/12/2014

This structure defines the Native 802.11 attributes of a packet that is to be sent by the miniport driver that is operating in Extensible Station (ExtSTA) mode.

Syntax

typedef struct DOT11_EXTSTA_SEND_CONTEXT {
  NDIS_OBJECT_HEADER  Header;
  USHORT  usExemptionActionType;
  ULONG  uPhyId;
  ULONG  uDelayedSleepValue;
  PVOID  pvMediaSpecificInfo;
  ULONG  uSendFlags;
} DOT11_EXTSTA_SEND_CONTEXT, *PDOT11_EXTSTA_SEND_CONTEXT;

Members

  • Header
    The type, revision, and size of the DOT11_EXTSTA_SEND_CONTEXT structure. This member is formatted as an NDIS_OBJECT_HEADER structure.

    The miniport driver must set the members of Header to the following values:

    Type

    This member must be set to NDIS_OBJECT_TYPE_DEFAULT

    Revision

    DOT11_EXTSTA_SEND_CONTEXT_REVISION_1

    Size

    This member must be set to sizeof(DOT11_EXTSTA_SEND_CONTEXT)

  • usExemptionActionType
    The type of encryption exemption for the packet. The following exemption types are defined:

    DOT11_EXEMPT_NO_EXEMPTION

    The packet is not exempt from any cipher operations that are performed by the 802.11 station.

    DOT11_EXEMPT_ALWAYS

    The packet is exempt from any cipher operations that are performed by the 802.11 station. The 802.11 station must transmit the packet unencrypted.

    DOT11_EXEMPT_ON_KEY_MAPPING_KEY_UNAVAILABLE

    The packet is exempt from any cipher operations that are performed by the 802.11 station only if the station does not have a key-mapping key for the packet’s destination media access control (MAC) address.

  • uPhyId
    The identifier (ID) of a PHY type on the 802.11 station. The 802.11 station must use the specified PHY to transmit the packet.

    The value of uPhyId must be one of the following:

    • The value of an entry in the list of active PHY types that is defined by the msDot11ActivePhyList MIB object. The miniport driver sets this MIB object to the list of PHYs that have been enabled for use over the current basic service set (BSS) network connection. For more information about the msDot11ActivePhyList MIB object, see OID_DOT11_ACTIVE_PHY_LIST.
    • The value of DOT11_PHY_ID_ANY. In this case, the 802.11 station can use any PHY from the list of active PHYs defined by the msDot11ActivePhyList MIB object.

    The miniport driver must fail the send request if the PHY specified by uPhyId is either not supported or has been disabled through a proprietary mechanism implemented by the independent hardware vendor (IHV). In this situation, the miniport driver sets the Status member of the NET_BUFFER_LIST structure to NDIS_STATUS_UNSUPPORTED_MEDIA and calls NdisMSendNetBufferListsComplete to complete the send request.

  • uDelayedSleepValue
    The time, in microseconds, before a response to the packet is expected. The uDelayedSleepValue member is only valid when all the following are true:

    The packet is a media access control (MAC) service data unit (MSDU) packet.

    The 802.11 station is operating in a power save (PS) mode. In this situation, the Extensible Station (ExtSTA) msDot11PowerSavingLevel management information base (MIB) object has any value except DOT11_POWER_SAVING_NO_POWER_SAVING. For more information about the msDot11PowerSavingLevel MIB value, see OID_DOT11_POWER_MGMT_REQUEST.

    The 802.11 station uses the value of uDelayedSleepValue to optimize network performance while operating in a PS mode. For example, depending on the PS mode, the 802.11 station might keep the radio turned on after the transmission of the packet if uDelayedSleepValue is small. By doing this, the network latency will be reduced for receiving the response.

  • pvMediaSpecificInfo
    A pointer to a buffer that contains media-specific information. This member should be NULL when the 802.11 NET_BUFFER_LIST structure with which this structure is associated comes from the native 802.11 framework itself (including any NET_BUFFER_LIST structures that come from an IHV extension).

    Otherwise, pvMediaSpecificInfo points to the out-of-band (OOB) data that is associated with the MediaSpecificInformation entry at the NetBufferListInfo member of the original 802.3 NET_BUFFER_LIST structure. pvMediaSpecificInfo allows the miniport driver to access the media-specific information from an IHV-specific 802.3 protocol driver.

  • uSendFlags
    A set of flags that define send attributes. Currently, there are no flags defined. This member should be zero.

Remarks

The miniport driver performs a send operation when its MiniportSendNetBufferLists is called. Each packet passed to the driver through this function is defined by a NET_BUFFER_LIST structure, which contains Native 802.11 out-of-band (OOB) data. The OOB data contains media-specific parameters that the 802.11 station uses when transmitting the packet.

The miniport driver accesses the Native 802.11 OOB data through the NET_BUFFER_LIST_INFO macro with the following parameters:

  • The _NBL parameter, which is passed the pointer to the NET_BUFFER_LIST structure that is used for the received 802.11 packet
  • The _Id parameter, which is passed the identifier (ID) value of MediaSpecificInformation

Requirements

Header

windot11.h

See Also

Reference

Native 802.11 Data Types
OID_DOT11_ACTIVE_PHY_LIST
NET_BUFFER_LIST
NdisMSendNetBufferListsComplete
OID_DOT11_POWER_MGMT_REQUEST
NET_BUFFER_LIST_INFO
Native 802.11 Wireless LAN Reference