Test.StationaryJitterMultiple

Article
02/27/2017

This test verifies that there is no jitter (within .5mm) reported by the device when three stationary contacts are placed on the device.

Test details

Associated requirements	Device.Input.PrecisionTouchpad.Precision.StationaryJitter System.Client.PrecisionTouchpad.PrecisionTouchpad See the system hardware requirements.
Platforms	Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86
Expected run time	~2 minutes
Categories	Certification
Type	Manual

Running the test

Before you run the test, complete the test setup as described in the test requirements: Mouse or other Pointing Device Testing Prerequisites.

Three precision contacts are necessary for this test. For the test to pass, the contact must be able to rest on the device with no jitter. We strongly recommend that a robot or precision rig be used to execute this test.

Carefully lower three contacts 11mm apart straight down anywhere on the touchpad.
Wait ten seconds (use the timer in the upper-right corner of the Logo tool).
Carefully raise the contacts.

If no jitter is detected, the tool will pass the iteration and move on to the next iteration. Otherwise it will fail the test and give an error.
Repeat for five iterations.

Troubleshooting

For troubleshooting information, see Troubleshooting Device.Input Testing.

Error	Description/Workaround
[12] interaction too short: #####	The contacts were down for less than the required ten seconds. The number given is the duration of the contacts, measured in tenths of milliseconds. Make sure you leave the contacts down for at least ten seconds.
[11] contact displacement too large: ###	Contacts moved or jitter farther than the allowed tolerance. The number given is the himetric distance moved, measured in hundredths of millimeters. Make sure the contacts are completely stationary on the device.

[12] interaction too short: #####

The contacts were down for less than the required ten seconds. The number given is the duration of the contacts, measured in tenths of milliseconds.

Make sure you leave the contacts down for at least ten seconds.

[11] contact displacement too large: ###

Contacts moved or jitter farther than the allowed tolerance. The number given is the himetric distance moved, measured in hundredths of millimeters.

Make sure the contacts are completely stationary on the device.

More information

Command syntax

Command	Description
ptlogo.exe Test.StationaryJitterMultiple.json	Runs the test.

File list

File	Location
ptlogo.exe	<testbinroot>\input\PrecisionTouchpad\
config.json	<testbinroot>\input\PrecisionTouchpad\
Test. Test.StationaryJitterMultiple.json	<testbinroot>\input\PrecisionTouchpad\

Send comments about this topic to Microsoft

Share via