Share via

NDISTest 6.5 - WlanGTKRefresh - OSStack

  • Article

The automated test validates the GTK offload behavior by placing the device in Connected Standby and then validating that the device can still send data packets when it resumes from sleep.

Test details

Associated requirements

Device.Network.WLAN.Base.MeetScanAndConnReq Device.Network.WLAN.CSBBase.MeetScanAndConnReq Device.Network.WLAN.CSBWoWLAN.MustSupportWakeOnWLAN Device.Network.WLAN.WoWLAN.ImplementWakeOnWLAN

See the device hardware requirements.

Platforms

Windows RT (ARM-based) Windows 8 (x64) Windows 8 (x86) Windows RT 8.1 Windows 8.1 x64 Windows 8.1 x86

Expected run time

~11 minutes

Categories

Certification Functional

Type

Automated

 

Running the test

Before you run the test, complete the test setup as described in the test requirements: Wireless LAN (802.11) Testing Prerequisites.

The following suites are available in this test:

  • PM_GtkRefresh

The PM_GtkRefreshsuite consists of the following:

Name Description

Pre-configuration

  • Rebind the operating system stack on the DUT and the SUT.

  • Configure one of the access point to use WPA2/AES.

  • Connect the DUT to the access point.

  • Connect the SUT to the access point.

  • Put the DUT to sleep (d2).

  • After 4 minutes, disconnect the SUT.

  • After 30 seconds, reconnect the SUT.

  • Ping the access point from the DUT.

 

Troubleshooting

For troubleshooting information, see Troubleshooting Wireless LAN (802.11) Tests.

More information

Command syntax

Parameter Description

AP1Password

The root password for the first physical access point.

AP1IPAddress

The IP address of the WAN port of the first physical access point.

AP2Password

The root password for the second physical access point.

AP2IPAddress

The root password for the second physical access point.

 

 

 

Send comments about this topic to Microsoft