Share via

Configure the Domain Used for User Name Authentication

  • Article

Applies To: Windows 7, Windows 8, Windows Server 2008, Windows Server 2008 R2, Windows Server 2012, Windows Vista

You can use this procedure to configure the domain that is used to authenticate user names that are submitted to Telnet Server by a client.

By default, if the Telnet server is a member of a domain, it sends names sent by Telnet Client to a domain controller in its own domain. If you change this value, Telnet Server can send user names to any domain trusted by the Telnet Server domain.

Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

To change the domain used for user name authentication

  • At a command prompt, type the following, and then press ENTER:

    tlntadmn [\\server] **config dom=**DomainName

    • \\server

      The name of the computer running Telnet Server you want to change. If this parameter is not present, then the command runs against the Telnet Server service installed on the local computer.

    • **config dom=**DomainName

      Specifies the domain to which user names are sent for authentication.

Formatting legend

Format Meaning

Italic

Information that the user must supply

Bold

Elements that the user must type exactly as shown

Between brackets ([])

Optional items

Additional considerations

  • Tlntadmn.exe must be run at a command prompt that was started with the Run as administrator option. If you do not run it at an elevated command prompt, you receive an Access is denied message.

  • The Tlntadmn.exe tool is installed with Telnet Server, so it might not be present on a computer that does not have Telnet Server installed.

  • You can determine the current domain used by Telnet Server to authenticate user names by running the following command:

    tlntadmn [\\server]

    Windows displays several current settings, including the current domain.

See Also

Concepts

Enable the Telnet Server Service
Grant Access to a Telnet Server
Configure Telnet Server Authentication
Configure Telnet Server to Allow Administrator Access by using Password Authentication
Configure the Command Interpreter Used by the Telnet Server
Configure the TCP Port Number Used by Telnet Server
Configure Idle Session Timeouts for Telnet Sessions
Configure the Number of Simultaneous Sessions Supported