Event ID 30031 — RRAS Route Ignoring
Applies To: Windows Server 2008 R2
.jpg)
A Router Information Protocol (RIP) for IP environment automatically adds and removes routes as networks are added and removed from the network. If the router is ignoring route updates, route configuration with peer routers might fail.
Event Details
| Product: | Windows Operating System |
| ID: | 30031 |
| Source: | Microsoft-Windows-RasRoutingProtocols-IPRIP2 |
| Version: | 6.1 |
| Symbolic Name: | IPRIPLOG_HOST_ROUTE_INVALID |
| Message: | IPRIPv2 is ignoring a host route to: %1 with next-hop: %2 which was advertised by a neighbor with IP address: %3, because the interface on which the route was received is configured to reject host routes. |
Resolve
Check RIP configuration
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To configure Routing Information Protocol version 2 (RIPv2):
- Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
- In the console tree, expand IPv4, and then click RIP.
- In the details pane, right-click the interface you want to configure, and then click Properties.
- Check the settings on the General, Security, Neighbors, and Advanced tabs.
Verify
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To verify that the Routing Table Manager (RTM) route has been added:
- Stop and restart the Routing and Remote Access service.
- Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
- Open Routing and Remote Access.
- In the console tree, click Server Status.
- In the details pane, right-click a server name, point to All Tasks, and click Restart.
- View the routing table. In the Routing and Remote Access snap-in, expand IPv4 or IPv6, right-click Static Routes, and then click Show IP Routing Table.
- Verify that the route has been added.