Share via

Event ID 20270 — RAS Connection

  • Article

Applies To: Windows Server 2008 R2

A server running Routing and Remote Access provides two different types of remote access connectivity: virtual private networking (VPN) and dial-up networking. VPN is the creation of secured, point-to-point connections across a private network or a public network, such as the Internet. A VPN client uses special TCP/IP-based protocols called tunneling protocols to make a virtual call to a virtual port on a VPN server. In dial-up networking, a remote access client makes a nonpermanent, dial-up connection to a physical port on a remote access server by using the service of a telecommunications provider, such as analog phone or ISDN. In contrast to dial-up networking, VPN is always a logical, indirect connection between the VPN client and the VPN server over a public network, such as the Internet.

Event Details

Product: Windows Operating System
ID: 20270
Source: RemoteAccess
Version: 6.1
Symbolic Name: ROUTERLOG_CONNECTION_ATTEMPT_FAILURE_COID
Message: The user: %1, attempting to connect on: %2, was disconnected because of the following reason: %3

Resolve

Review the remote access service error code

There is not enough information available in the Routing and Remote Access service event message to provide a recommendation for resolution of the problem. If you continue to get this error, contact Microsoft Product Support Services. For more information, see https://go.microsoft.com/fwlink/?LinkId=52267.

For more information about remote access service error codes, see article 163111 in the Microsoft Knowledge Base (https://go.microsoft.com/fwlink/?LinkID=91455).

Verify

To verify that the remote access server can accept connections, establish a remote access connection from a client computer.

To create a VPN connection:

  1. Click Start, and then click Control Panel.
  2. Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
  3. Click Connect to a workplace, and then click Next.
  4. Complete the steps in the Connect to a Workplace wizard.

To connect to a remote access server:

  1. In Network and Sharing Center, click Manage network connections.
  2. Double-click the VPN connection, and then click Connect.
  3. Verify that the connection was established successfully.

RAS Connection

Routing and Remote Access Service Infrastructure