Event ID 20111 — RRAS Demand-Dial Connections
Applies To: Windows Server 2008 R2
.jpg)
A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet. Demand-dial connections are either on-demand (the point-to-point connection is only established when needed) or persistent (the point-to-point connection is established and then remains in a connected state). Demand-dial interfaces typically require an authentication process to become connected. The equipment required by a demand-dial interface is a port on a device.
Event Details
| Product: | Windows Operating System |
| ID: | 20111 |
| Source: | RemoteAccess |
| Version: | 6.1 |
| Symbolic Name: | ROUTERLOG_CONNECTION_ATTEMPT_FAILED |
| Message: | A demand-dial connection to the remote interface: %1 on port: %2 was successfully initiated but failed to complete successfully because of the following error: %3 |
Resolve
Reinitialize the demand-dial connection
Check that there is communication between the calling and answering demand-dial routers.
To initiate the on-demand connection on the calling router:
- On the calling router, in the Routing and Remote Access snap-in, click Network Interfaces.
- Right-click the demand-dial interface for which you want to initiate a connection, click Connect, and then confirm that the connection was established.
Verify
If the calling router uses a dial-up connection to the local ISP, the local ISP assigns the router a temporary IP address. You can confirm that this IP address exists by typing ipconfig at a command prompt.
To perform the following procedure, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.
To check the status of the demand-dial interface:
- Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
- In the console tree, click Network Interfaces.
- In the details pane, in the Connection State column, verify that the demand-dial interface that matches the user name for the credentials of the calling router is connected.