Share via

Event ID 5050 — IIS Application Pool Configuration

  • Article

Applies To: Windows Server 2008 R2

To ensure Web site and Web application isolation, Internet Information Services (IIS) application pools must be configured to have unique names and correctly configured identities. If errors occur during the configuration of an application pool, the application pool may not be available to serve the Web sites and Web applications that are assigned to it.

Event Details

Product: Internet Information Services
ID: 5050
Source: Microsoft-Windows-WAS
Version: 7.5
Symbolic Name: WAS_EVENT_WMS_APP_POOL_ID_TOO_LONG_ERROR
Message: The application pool id '%1' exceeds length limits. It is '%2' characters and cannot be more than '%3' characters. The application pool will therefore be ignored.

Resolve

Correct application pool configuration

Correct the application pool configuration as indicated in the event log message. If the problem persists, check the permissions on the ApplicationHost.config file and make sure that all required services are started. In some cases, you may have to stop and restart WAS.

To perform these procedures, you must have membership in Administrators, or you must have been delegated the appropriate authority.

Edit the application pool configuration by using Internet Information Services (IIS) Manager

To edit the application pool configuration:

  1. Click Start, click Control Panel, and then click Administrative Tools.
  2. Right-click Internet Information Services (IIS) Manager and select Run as administrator.
  3. In the Connections pane, expand the server node and select Application Pools.
  4. In Features View, select the application pool you want to configure.
  5. In the Actions pane, click Advanced Settings.
  6. Correct the application pool configuration as indicated by the event log message.

Stop and restart WAS

To stop and restart WAS:

Note: Stopping WAS will also stop any other services that depend on it, including the World Wide Web Publishing Service (W3SVC). Thus, you may also have to restart W3SVC or other services.

  1. Open an elevated Command Prompt window. Click Start, point to All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.
  2. At the command prompt, type net stop was /y.
  3. At the command prompt, type net start was.
  4. To restart W3SVC, from the command prompt, type net start w3svc. Also, start any other services that were stopped when WAS was shut down.

Verify

An application pool that is correctly configured will start without incident. To verify that the application pool has started, use the following procedure.

To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.

To verify that an application pool has started:

  1. Click Start, click Control Panel, and then click Administrative Tools.
  2. Right-click Internet Information Services (IIS) Manager and select Run as administrator.
  3. In the Connections pane, expand the server node and select Application Pools.
  4. In Features View, the Status column for the application pool will indicate Started if the application pool has started.

IIS Application Pool Configuration

Internet Information Services (IIS) 7.5