Dos

Specifies that the MS-DOS subsystem is to maintain a link to the upper memory area (UMA) or is to load part of itself into the high memory area (HMA).

Syntax

dos={high|low}[{,umb|,noumb}]

dos={[high,|low,}]{umb|noumb}

Parameters

{ high | low } : Specifies whether the MS-DOS subsystem should attempt to load a part of itself into the HMA. Use high to enable the MS-DOS subsystem to load itself into the HMA. Use low to keep all of the MS-DOS subsystem in conventional memory. The default setting is low.

{ umb | noumb } : Specifies whether the MS-DOS subsystem should maintain a link between conventional memory and the UMA. Umb provides this link. Noumb disconnects this link. The default setting is noumb.

/?   : Displays help at the command prompt.

Remarks

• Installing Himem.sys for dos=umb or dos=high 

  You must install the Himem.sys device driver before you specify either dos=umb or dos=high.

• Using umb 

  You must specify dos=umb to load programs and device drivers into the upper memory area (UMA). By using UMA, you free more space in conventional memory for programs. In addition, you must install an upper memory block (UMB) provider.

• Using the high parameter

  If you specify the high parameter, the MS-DOS subsystem attempts to load part of itself into the high memory area (HMA). Loading part of MS-DOS into the HMA frees conventional memory for programs.

• Combining parameters

  If you specify the high parameter, the MS-DOS subsystem attempts to load part of itself into the high memory area (HMA). By loading part of MS-DOS into HMA, you free conventional memory for programs.

  You can include more than one parameter on a single dos command line, using commas to separate them. For example, the following syntax is valid:

  dos=umb,low
  dos=high,umb

  You can place the dos command anywhere in your Config.nt or equivalent startup file.

Formatting legend

Devicehigh

Loadhigh

Command-line reference A-Z