Edit

Share via

Receiving Remote NDIS QoS Parameters

  • Article

Remote NDIS Quality of Service (QoS) parameters are those that are received from a remote peer that the network adapter is connected to over the data link. The miniport driver discovers these parameters through the Data Center Bridging Exchange (DCBX) protocol that is specified by the IEEE 802.1Qaz draft standard.

The driver must follow these guidelines for managing remote QoS parameters:

  • The miniport driver must issue an NDIS_STATUS_QOS_REMOTE_PARAMETERS_CHANGE status indication when its remote NDIS QoS parameters are either received from a peer for the first time or change later. For more information on this procedure, see Indicating Changes to the Remote NDIS QoS Parameters.

  • The miniport driver can use the remote NDIS QoS parameters to resolve its operational NDIS QoS parameters only if the local Data Center Bridging Exchange (DCBX) Willing state is enabled on the network adapter. The miniport driver can also resolve its operational QoS parameters based on any proprietary QoS settings that are defined by the independent hardware vendor (IHV).

    For more information about this procedure, see Resolving Operational NDIS QoS Parameters.

    For more information about the local DCBX Willing state, see Managing the Local DCBX Willing State.

For more information about NDIS QoS parameters, see Overview of NDIS QoS Parameters.