Edit

Share via

Services and RPC/TCP

  • Article

Starting with Windows Vista, the service control manager (SCM) supports remote procedure calls over both Transmission Control Protocol (RPC/TCP) and named pipes (RPC/NP). Client-side SCM functions use RPC/TCP by default.

RPC/TCP is appropriate for most applications that use SCM functions remotely, such as remote administration or monitoring tools. However, for compatibility and performance, some applications might need to disable RPC/TCP by setting the registry values described in this topic.

When a service calls a remote SCM function, the client-side SCM first attempts to use RPC/TCP to communicate with the server-side SCM. If the server is running a version of Windows that supports RPC/TCP and allows RPC/TCP traffic, the RPC/TCPP connection will succeed. If the server is running a version of Windows that does not support RPC/TCP, or supports RPC/TCP but is operating behind a firewall which allows only named pipe traffic, the RPC/TCP connection times out and the SCM retries the connection with RPC/NP. This will succeed eventually but can take some time (typically more than 20 seconds), causing the OpenSCManager function to appear blocked.

TCP does not carry user credentials specified with a net use command. Therefore, if RPC/TCP is enabled and sc.exe is used to attempt to access the specified service, the command could fail with access denied. Disabling RPC/TCP on the client side causes the sc.exe command to use a named pipe that does carry user credentials, so the command will succeed. For information about sc.exe, see Controlling a Service Using SC.

Note

A service should not provide explicit credentials to a net use command, because those credentials might be inadvertently shared outside of the service boundaries. Instead, the service should use client impersonation to impersonate the user.

 

RPC/TCP Registry Values

RPC/TCP is controlled by the SCMApiConnectionParam, DisableRPCOverTCP, and DisableRemoteScmEndpoints registry values, which are all under the HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control key. All of these values have a REG_DWORD data type. The following procedures show how to use these registry values to control RPC/TCP.

The following procedure describes how to disable RPC/TCP on the client side.

To disable RPC/TCP on the client side

  1. Combine the SCMApiConnectionParam registry value with the mask value 0x80000000.
  2. Restart the application that calls the OpenSCManager function.

The following procedure describes how to disable TCP on the server side.

To disable TCP on the server side

  1. Set the DisableRPCOverTCP registry value to 1.
  2. Restart the server.

The following procedure describes how to disable both RPC/TCP and RPC/NP on the server (for example, to reduce the attack surface).

To disable both RPC/TCP and RPC/NP on the server

  1. Set the DisableRemoteScmEndpoints registry value to 1.
  2. Restart the server.

The SCMApiConnectionParam registry value can also be used to specify the RPC/TCP time-out interval, in milliseconds. For example, a value of 30,000 specifies a time-out interval of 30 seconds. The default is 21,000 (21 seconds).