Partager via

Running ETPrep.exe

  • Article

5/10/2007

After First Boot Agent (FBA) runs and Enhanced Write Filter (EWF) is configured, you must run the ETPrep.exe tool before you can copy your run-time image to CD.

To run ETPrep.exe

  1. Boot the target system to the Windows XP Embedded run-time image on the hard disk.

  2. Open a command prompt.

  3. Navigate to the \WINDOWS\system32 directory and type the following command:

    etprep /all

    If the operation is successful, the following text is displayed:

    Deleted EWFpartitions = 1.
Swapped ElTorito volume drive E: with Boot volume C: .

    The EWF partition on the disk has been deleted, and the boot drive letter has been reassigned to the El Torito CD. This then becomes the boot volume when you boot the target system from CD-ROM.

    Note

    The current boot partition may no longer be bootable after running ETPrep.exe because the drive letters have changed. Therefore, be sure that you are ready to burn the final CD before you complete this step.

  4. After you run ETPrep, the system should immediately reboot. If it does not, manually restart the system.

    Note

    Do not boot to your run-time image. Because the drive letters between the C: boot partition and the deployment device (CD-ROM) have been swapped, any attempt to access the file system will hang the system.

  1. Boot the target system to the Windows XP Embedded run-time image on the hard disk.

  2. Open a command prompt.

  3. Navigate to the \WINDOWS\system32 directory and type the following command:

    etprep /all

    If the operation is successful, the following text is displayed:

    Deleted EWFpartitions = 1.
Swapped ElTorito volume drive E: with Boot volume C: .

    The EWF partition on the disk has been deleted, and the boot drive letter has been reassigned to the El Torito CD. This then becomes the boot volume when you boot the target system from CD-ROM.

    Note

    The current boot partition may no longer be bootable after running ETPrep.exe because the drive letters have changed. Therefore, be sure that you are ready to burn the final CD before you complete this step.

  4. After you run ETPrep, the system should immediately reboot. If it does not, manually restart the system.

    Note

    Do not boot to your run-time image. Because the drive letters between the C: boot partition and the deployment device (CD-ROM) have been swapped, any attempt to access the file system will hang the system.

See Also

Tasks

Writing a Bootable CD-ROM

Concepts

How to Create a Bootable CD-ROM
How to Configure EWF for CompactFlash
ETPrep

Other Resources

Enhanced Write Filter
Bootable CD-ROM