Partager via


NEC Solution Gear 2-Vr5500 Development Kit Supported Features (Windows Embedded CE 6.0)

1/5/2010

The following table shows the hardware components that are supported in the board support package (BSP) for the NEC Solution Gear 2-Vr5500 Development Kit for Vr5432/5500 microprocessors.

Hardware component NEC Solution Gear 2-Vr5500 hardware support NEC Solution Gear 2-Vr5500 BSP support

RAM

128 MB

RAM image

Flash

32 MB Intel DA28F640J5

Yes

Boot ROM

512 KB

Not applicable

Timers

2

Yes

Real-time clock

Yes

Yes

VGA

PCI card

All supported PCI video cards

LCD

Yes

Yes

Ethernet

Built-in AMD AM79C973

Debug and Product Ethernet through all supported PCI Ethernet cards

Serial

2

Yes. The top one is for debug messages and the bottom one is for product serial.

PCMCIA or CF

PCI card

TI1250

Mouse

PS/2

Yes

Keyboard

PS/2

Yes

Hardware reset through a cold boot

Yes

Yes

Hardware reset through a warm boot

Yes

Yes

Software reset through a warm boot

Not applicable

Yes

Touch controller

No

No

Universal serial bus (USB) host

PCI card and built-in OHCI controller

Yes

USB function

PCI card (Netchip 2890)

Yes

Serial Infrared (SIR)

Yes

Yes

Fast Infrared (FIR)

Yes

No

Audio output

PCI card

Yes

Audio input

PCI card

Yes

Parallel port for printing

1

Yes

Integrated Device Electronics (IDE)

1

Yes

Smart card

USB and PCMCIA Readers

Not tested

Floppy disk

No

No

TV output

PCI card

Yes

Floating point unit

Yes

Yes

Expansion connector

PCI and compact PCI

Yes

PCI slots

4

Yes

Compact PCI or PCI extender

Both (Use PCI4 slot for extender)

Yes

Logic analyzer probes

Yes

Yes

IEEE 1149.1-compliant (JTAG)

Yes

Yes

Debug LEDs

Yes

One digit

Companion or add-on cards

Vr5432/Vr5500 companion

Yes

Form factor

Custom

Not applicable

NEC Solution Gear 2-Vr5500 Development Kit Hardware Restrictions and Limitations

Keep in mind the following NEC Solution Gear 2-Vr5500 Development Kit restrictions and limitations:

  • The PCI INTC routed through the ALI M1535+ chip on the baseboard does not work properly. The PCI card using this interrupt will not work. This situation occurs only with a special card or when the PCI extension box is used, because the interrupt is not attached to the PCI INTA signal on a baseboard PCI slot.

See Also

Tasks

How to Use the BSP for the NEC Solution Gear 2-Vr5500 Development Kit
Setting up the NEC Solution Gear 2-Vr5500 Development Kit Hardware