lineMonitorDigits (Windows Embedded CE 6.0)

1/6/2010

This function enables and disables the unbuffered detection of digits received on the call. Each time a digit of the specified digit mode is detected, a message is sent to the application indicating which digit has been detected.

Syntax

LONG WINAPI lineMonitorDigits(
  HCALL hCall,
  DWORD dwDigitModes 
);

Parameters

• hCall
  Handle to the call on which digits are to be detected. The call state of hCall can be any state except idle or disconnected.

• dwDigitModes
  Digit mode or modes that are to be monitored. If dwDigitModes is zero, digit monitoring is canceled. This parameter uses one or more of the LINEDIGITMODE constants.

Return Value

Returns zero if the request succeeds or a negative error number if an error occurs. The following table shows the return values for this function.

Remarks

This function is considered successful if digit monitoring has been correctly initiated, not when digit monitoring has terminated. Digit monitoring remains in effect until it is explicitly disabled by calling lineMonitorDigits with dwDigitModes set to zero, until the call transitions to idle, or when the application deallocates its call handle for the call. Although this function can be invoked in any call state, digits are usually detected only while the call is in the connected state.

Each time a digit is detected, a LINE_MONITORDIGITS message is sent to the application passing the detected digit as a parameter.

An application can use lineMonitorDigits to enable or disable unbuffered digit detection. Monitoring of digits on a conference call applies only to the hConfCall, not to the individual participating calls.

Requirements

See Also

Reference

LINE_GATHERDIGITS

Concepts

TAPI Line Device Functions