Partager via

Event ID 1031 — WDSServer Network Availability

  • Article

Applies To: Windows Server 2008

Network connectivity makes communication possible among the WDSServer service, client computers, and Active Directory directory services. Without this communication, the WDSServer service cannot deploy images to client computers. 

Event Details

Product: Windows Operating System
ID: 1031
Source: WDSServer
Version: 6.0
Symbolic Name: E_WDSSERVER_RPC_INVALID_PACKET_SECURITY
Message: An authenticated request was received by the RPC server on %1 endpoint from %2 but the request did not have packet-level privacy. Windows Deployment Services server requires all authenticated requests to have packet-level privacy. This request will be ignored. The binary data contains the first 32 bytes of the request.

Resolve

Contact the vendor of your custom client

The authentication settings in custom deployment clients must match those of the registered provider. For example, if the provider requires authorized remote procedure calls (RPCs) but the client uses unauthorized RPCs, problems will occur.

To resolve this, contact the vendor of your custom deployment client for configuration and troubleshooting support.

Verify

You can verify network connectivity either from a client computer or from the server by using one of the following two procedures.

To verify that the server has connectivity (from a client computer):

  1. Open the Command Prompt window. (Click Start, point to All Programs, click Accessories, and then click Command Prompt.)
  2. At the command prompt, type ping <IP address|fully qualified domain name> to contact the Windows Deployment Services server.
  3. Try to boot the client computer by doing a Pre-Boot Execution Environment (PXE) boot. Make sure that the boot menu and image selection pages are displayed.

To verify that the server has connectivity (from the Windows Deployment Services server):

  1. Open the Command Prompt window. (Click Start, point to All Programs, click Accessories, and then click Command Prompt.)
  2. At the command prompt, type ping <IP address|fully qualified domain name> to contact a remote computer.

WDSServer Network Availability

Windows Deployment Services