Event ID 11151 — DNS Client Registration
Applies To: Windows Server 2008
.jpg)
A computer that is configured to use Dynamic Host Configuration Protocol (DHCP) to obtain IP addresses can automatically register its IP address and Domain Name System (DNS) name with the DNS server that is authoritative for the zone that hosts its domain. This eliminates the need for an administrator to manage host (A or AAAA) resource records for client computers. Problems with automatic registration do not prevent a computer from accessing the network, but they can prevent other network computers from being able to locate the computer.
Event Details
| Product: | Windows Operating System |
| ID: | 11151 |
| Source: | DnsApi |
| Version: | 6.0 |
| Symbolic Name: | EVENT_DNSAPI_REGISTRATION_FAILED_SERVERFAIL |
| Message: | The system failed to register host (A) resource records for the network adapter with these settings: Adapter Name: %1 Host Name: %2 Primary Domain Suffix: %3 DNS server list: %4 Sent update to server: %5 IP Address(es): %6% This DNS registration failure was caused by DNS server failure. This might be due to a zone transfer that has locked the DNS server for the zone that your computer needs to register itself with. (The applicable zone typically corresponds to the adapter-specific domain suffix that was indicated above.) You can retry DNS registration of the network adapter and its settings by typing "ipconfig /registerdns" at a command prompt. If the problems persists, contact your network administrator. |
Resolve
Retry DNS registration
When your computer is assigned a new network address automatically, it attempts to notify the DNS server of the change of address. A problem occurred when your computer made this attempt. Often, this is a transient condition, although it can indicate a problem with the DNS server. This condition rarely causes problems for your computer unless you share resources such as folders or printers.
Although it is not necessary, you can direct your computer to try the DNS registration again.
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To register your computer's address with the DNS server:
- On the DNS client computer, open a command prompt. To open an elevated Command Prompt window, click Start, point to All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.
- At the command prompt, type ipconfig /registerdns, and then press ENTER.
If the problem persists, contact your network administrator and provide the information in the event message. If you are a network administrator, see Troubleshooting Dynamic Updates (https://go.microsoft.com/fwlink/?LinkId=103842) for information about troubleshooting DNS registration.
Verify
Use the ipconfig /registerdns command to register the computer's network name and address with a DNS server and then check the event log for errors.
To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.
To register the computer's network name and address with a DNS server:
On the DNS client, open a command prompt. To open an elevated Command Prompt window, click Start, point to All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.
Type the following command, and then press ENTER:
ipconfig /registerdns
Wait 15 minutes, and then check the event log to verify that a DNSapi event with an ID in the range 11150 through 11167 was not logged after you ran the command.