Partager via


Reset-HcsFactoryDefault

Reset-HcsFactoryDefault

Resets one or both controllers to a factory default state.

Syntaxe

Parameter Set: Default
Reset-HcsFactoryDefault [[-Format] <String> ] [[-Scope] <ClusterScope> ] [-Force] [ <CommonParameters>]

Description détaillée

The Reset-HcsFactoryDefault cmdlet resets one or both controllers to a factory default state. If you reset both controllers, you lose all data, metadata, and controller settings. The controllers revert to the operating system that the factory installed.

If you use Reset-HcsFactoryDefault to reset only one controller, that controller gets the current operating system image from its peer controller. You should reset only one controller if the peer controller is running and is in a healthy state. You do not lose any data if you reset only one controller.

The default behavior of this cmdlet is to reset both controllers.

Paramètres

-Force

Force la commande à s’exécuter sans demander confirmation à l’utilisateur.

Alias

none

Obligatoire ?

false

Position ?

named

Valeur par défaut

none

Accepter l’entrée de pipeline ?

false

Accepter les caractères génériques ?

false

-Format<String>

Specifies the format for how the shared serial-attached SCSI (SAS) disks where customer data is stored are formatted.

Alias

none

Obligatoire ?

false

Position ?

1

Valeur par défaut

Quick

Accepter l’entrée de pipeline ?

false

Accepter les caractères génériques ?

false

-Scope<ClusterScope>

Specifies the scope. Les valeurs acceptables pour ce paramètre sont :

-- Cluster. Disable support access for both nodes. This option resets both controllers. This option loses all data. You must run setup again. This is the default.
-- Controller. Disable support access for the local node only. This option resets only the current controller. This option resets the current controller. That controller forms a cluster with the peer controller once the reset is complete. No data loss occurs in this process.

Alias

none

Obligatoire ?

false

Position ?

2

Valeur par défaut

Cluster

Accepter l’entrée de pipeline ?

false

Accepter les caractères génériques ?

false

<CommonParameters>

Cette applet de commande prend en charge les paramètres courants : -Verbose, -Debug, -ErrorAction, -ErrorVariable, -OutBuffer et -OutVariable. Pour plus d’informations, consultez about_CommonParameters (https://go.microsoft.com/fwlink/p/?LinkID=113216).

Entrées

Le type d’entrée correspond au type des objets que vous pouvez transmettre à l’applet de commande.

Sorties

Le type de sortie est le type des objets émis par l’applet de commande.

Exemples

Example 1: Reset both controllers to the default factory state

This command resets both controllers to the default factory state.

PS C:\> Reset-HCSFactoryDefault

Example 2: Reset both controllers to the factory default state without confirmation

This command resets both controllers to the factory default state. The user is not prompted for confirmation.

PS C:\> Reset-HCSFactoryDefault -Force

Example 3: Reset the current controller to the factory default state

This command resets the current controller to the factory default state.

PS C:\> Reset-HCSFactoryDefault -Scope Controller